7.5
SETTING POWER SAVE MODE
Using OSD Menu
This monitor is equipped with a Power Save mode under RGB input
modes. When there are no signals detected by the monitor, the monitor
will automatically go into sleep mode until signal is restored.
1 Press the MENU on the monitor panel or remote control.
2 Use the SEL
or SEL
menu.
3 Press the ADJ
key to confirm the selection.
=> Various options are available in the SETUP menu.
4 Use the SEL
or SEL
5 Press the ADJ
key to confirm selection.
=> The POWER SAVE menu appears.
6 Use the ADJ
or ADJ
to power down when no signal is detected (1MIN, 2MIN, 3MIN,
4MIN and 5MIN).
7 Press the SEL
key to confirm setting and return to previous
menu.
Note:
To turn on the monitor from sleep mode, simply follow Power On
procedure.
45
User Manual BDS4223V
key to select the SETUP option from the
key to select the POWER SAVE option
key to select the desired amount of time