Advertisement
Figure 2-9
Figure 2-10
Figure 2-11 — Headrest guide installation
Figure 2-12 — Back Panel installation
Page 8
© Copyright 2016 Specter Off-Road, Inc.
All rights reserved
9.
The procedure followed to reinstall the headrest
guides is the same for both early and late 40 series
bucket seats. Start by locating and marking the
headrest guide holes in the top of the seat back. Feel
for the indentation with your finger and use a ball point
pen to mark an X across the center (figure 2-9).
10. Hold a guide up to the X to get an idea of how long
to make the cuts. It is better to under cut the X and
adjust it if needed. Be careful not to over cut the vinyl.
Cut the X with a sharp utility knife (figure 2-10).
11. Push the guide through the hole until it snaps
into place.
73-78 models, the guide slopes to the back of
the vehicle.
79-84 models, the guide with catch button is put
in the hole near the door of vehicle and the button
faces the door.
12. To reinstall back panel, position it on the seat back.
Use a strait pin to locate the screw holes in the seat
frame through the screw holes in the panel and vinyl
(figure 2-12).
13. Once you locate the screw hole you may need to
punch a larger hole with an awl or nail. Fasten the
panel by pushing a screw through the vinyl. Work
diagonally at first, corner to corner to center the panel
on the seat back and do not set the screws until they
are all in place (figure 2-13).
11. Reassemble and reinstall the seats.
Figure 2-13 — Back Panel installation
Specter Off-Road, Inc. 21600 Nordhoff St.
Chatsworth, CA 91311 USA, www.sor.com,
sor@sor.com, (818) 882-1238, Fax: (818) 882-7144
Advertisement
