Advertisement
Parts List
2 bottom seat covers
2 back rest cover
Retainer wire
Hog rings
Preparation
1.
READ THESE INSTRUCTIONS IN THEIR ENTIRETY BEFORE YOU PROCEED.
2.
Unbolt and remove your seats from your Land Cruiser.
3.
Detach the bottom cushion from the backrests. Remove the seat belts where applicable and remove the pivot
brackets from the sides of the seat. Disassemble one seat at a time so you have a reference.
4.
Clean and repaint mounting brackets as necessary. Replace any damaged, rusted or missing hardware.
Replacement parts can be purchased from Specter Off-Road. Now is also a good time to service the seat
adjustment tracks. Clean and re-lubricate the tracks
5.
Your kit came with a length of retainer wire. You have been supplied with enough to properly install your new SOR
seat covers. This wire is used to reinforce hems that attach the vinyl to seat frame. Pass the curled end of the wire
through the mounting seams of the seat cover. The curl in the wire prevents the sharpened ends of the cut wire
from damaging the vinyl. Cut the wire to length leaving enough excess at each end of the hem to curl into a small
loop. Make a ½ curl in the newly cut ends with a pair of pliers.
6.
It is not advisable to install this kit in temperatures under 75 degrees Fahrenheit. Lay the covers in the sun to
warm them. Work in a clean environment. Use an old blanket or towel as a work surface to prevent damage to
your new seat covers during the installation process.
Page 2
© Copyright 2016 Specter Off-Road, Inc.
All rights reserved
Tools Required
Wire cutters
12, 14 & 17 mm Wrenches
Open End or Socket
Phillips Screwdriver
Hog Ring Pliers
Pliers
Scissors
Utility Knife
Awl
4 Small kitchen trash bags
(Not included)
Specter Off-Road, Inc. 21600 Nordhoff St.
Chatsworth, CA 91311 USA, www.sor.com,
sor@sor.com, (818) 882-1238, Fax: (818) 882-7144
Advertisement
