Ccc Mpls Vll Configuration Example (1) - H3C S9500 series Operation Manual

Operation Manual – MPLS VLL
H3C S9500 Series Routing Switches

1.2.2 CCC MPLS VLL Configuration Example (1)

I. Network requirements
CEs and the corresponding PEs shown in
GigabitEthernet ports. Data is encapsulated as Ethernet packets at the data link layer. A
local connection is required between CE-A and CE-B, and a remote connection
between CE-A and CE-C.
II. Network diagram
L oca l co nn ectio n
CE A
Figure 1-5 Network diagram for CCC MPLS VLL (1)
III. Configuration procedure
1) Configure PE-A.
# Enable MPLS globally.
[H3C] mpls lsr-id 1.1.1.1
[H3C] mpls
# Enable MPLS VLL globally.
[H3C] mpls l2vpn
# Configure VLAN 211.
[H3C] vlan 211
[H3C-vlan211] port gigabitethernet 2/1/1
[H3C-Vlan211] interface vlan-interface 211
[H3C-Vlan-interface211] quit
# Configure VLAN 212.
[H3C] vlan 212
[H3C-vlan212] port gigabitethernet 2/1/2
[H3C-vlan212] interface vlan-interface 212
[H3C-Vlan-interface212] quit
# Configure VLAN 213.
[H3C] vlan 213
C E B
V LA N2 13
V LA N2 11
V L AN 21 4
V LA N 21 2
P E A
Figure 1-5 are interconnected through their
V L AN 21 2
P E B
P
Rem ote con ne ctio n
1-8
Chapter 1 MPLS VLL
V L AN 21 1
CE C