Outdoor Unit Removal Procedure (Cu-3E23Sbe) - Panasonic CU-2E18SBE Service Manual

16.1.4 Removing the Propeller Fan and Fan Motor
1. Remove the cabinet top plate and cabinet
front plate.
2. Remove the propeller fan by removing the nut
turning clockwise at its center.
3. Disconnect the connector of the fan motor
from the control board.
4. Loosen the 4 screws at the fan motor
mounting then remove the fan motor.

16.2 Outdoor Unit Removal Procedure (CU-3E23SBE)

Caution! When handling electronic controller, be careful of electrostatic discharge.
16.2.1 Removing the Cabinet Top Plate and Cabinet Front Plate
1. Remove the cabinet top plate (remove the
8 screws).
2. Remove the 8 screws (1 on the center, 3 at
the top and 4 at the bottom) securing the
cabinet front plate, release the 2 hooks (1
each at the left and right), and pull the cabinet
front plate toward front side.
2
10 mm
box wrench
4
2
Tabs
64
1