Zanussi ZRA40113WA User Manual page 6

Problem
Water flows inside the refrig-
erator.
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
REPLACING THE LAMP
1. Disconnect the plug from the mains socket.
2. Push the movable part of the lamp cover (1) to
unhook it.
3. Remove the lamp cover (2).
1
6
Possible cause
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
2
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
4. Replace the bulb with one of the same power
and shape, specifically designed for household
appliances.
5. Install the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light
switches on.
Solution