Tascam MINISTUDIO CREATOR US-42 Owner's Manual page 18

5 ASIO setting area (Windows only)
This turns ASIO use on or off.
Turn this ON when using a plug-in that supports
ASIO on signals being input to the unit.
Options: ON, OFF
CAUTION
If this is left ON when not using a plug-in that
supports ASIO, input signals will not be output.
6 Reverb type switches
Use to select the type of reverb.
Depending on the type, the density and level of
the reverb sound changes.
Options: HALL, ROOM, LIVE, STUDIO, PLATE, OFF
7 PRE DELAY knob
Set the amount of delay until the first reverberations.
The larger the value, the larger the reverberations
make the room sound.
Range: 0–250 ms
8 REVERB TIME knob
Set the amount of time that the reverberations
continue.
The larger the value, the longer they continue.
Range: 0.1–10 s
9 DIFFUSION knob
Sets the breadth of the reverberations.
Range: 0–100
0 Trigger sound area
Make trigger sound settings here. (See "PON
trigger display area overview" on page 19.)
q COMPUTER fader
Use this to adjust the amount of signal returned
from the computer.
The adjusted value is shown below the fader.
w MASTER fader
Use this to adjust the level of the output signal.
The adjusted value is shown below the fader.
e OUTPUT setting area
Set whether the MASTER signal output is mono
or stereo.
Options: STEREO, MONO
r USB DELAY setting area
During live broadcasts, screen capture latency can
result in timing differences between video and
audio. By intentionally adding delay to the audio
output by USB, you can correct this difference.
Range: 0 ms–500 ms
t DIRECT MONITOR setting area
Set whether the MASTER signal output is mono
or stereo.
Options: STEREO, MONO, OFF
i This only functions when the CREATOR/
BROADCAST switch on the unit is set to CREATOR.
18
TASCAM MiNiSTUDIO CREATOR
This can be selected when set to BROADCAST,
but it will always function as MONO.
8 EQUALIZER (4-band parametric EQ)
display area overview
1 EQ graph
This shows the frequency response with the
current equalizer settings.
The graph is shown even when the equalizer is off.
2 GAIN (HIGH/HIGH MID/LOW MID/LOW) knobs
Set the amount the levels are increased or decreased
for the HIGH, HIGH MID, LOW MID and LOW bands.
Range: ±12 dB (default: 0 dB)
3 FREQ (HIGH/HIGH MID/LOW MID/LOW) knobs
Set the cutoff frequencies of the HIGH, HIGH MID,
LOW MID and LOW bands.
Ranges
HIGH: 1.7 kHz–18.0 kHz (default: 5 kHz)
HIGH MID: 32 Hz–18.0 kHz (default: 1.2 kHz)
LOW MID: 32 Hz–18.0 kHz (default: 300 Hz)
LOW: 32 Hz–1.6 kHz (default: 80 Hz)
4 Q (HIGH MID/LOW MID) knobs
Set the acutenesses of the peaks of the HIGH MID
and LOW MID bands.
The higher the value the more acute it becomes,
making it affect a narrower frequency band.
The lower the value, the less acute it becomes,
making it affect a broader frequency band.
Ranges
HIGH MID: 0.25–16.00 (default: 1.00)
LOW MID: 0.25–16.00 (default: 1.00)
5 LCF button
Click the LCF button to enable a low cut filter that
cuts noise and other sounds at low frequencies.
The LCF button lights when enabled. (Default: off )