AEG L9FSC969R User Manual page 38

38 www.aeg.com
Problem
The appliance makes an
unusual noise and vi-
brates.
The programme duration
increases or decreases
during programme exe-
cution.
The washing results are
not satisfactory.
Too much foam in the
drum during the washing
cycle.
Excessive consumption
of salt.
The drum light does not
go on.
Possible solution
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the
drum.
Make sure that the appliance receives electrical power.
This problem may be caused by a failure of the appliance.
Contact the Authorised Service Centre. If you need to open
the door, please read carefully «Emergency door opening».
Make sure the levelling of the appliance is correct. Refer to 'In-
stallation'.
Make sure that the packaging and/or the transit bolts are re-
moved. Refer to 'Installation'.
Add more laundry in the drum. The load may be too small.
The ProSense function is able to adjust the programme dura-
tion according to the type and the laundry load size. Refer to
'The ProSense load detection' in 'Daily Use' chapter.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you
wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Make sure that no other type of detergent has been poured
Salt
the compartment . In this case, refer to 'Eliminating deter-
gent or other additives from salt compartment'.
Make sure that no salt has been poured in the compartment
. If it happens, run a rinse cycle or run the washing cycle
again.
Reduce the quantity of detergent.
Check if the water softener has been set to act also during
rinse phase. Refer to 'How to set the water hardness level' in
'The Water Softener technology (Soft Water)' chapter.
Make sure that the LED lamp is not burned. To replace it, con-
tact the Authorised Service Centre.