Advertisement
Quick Links
GE
Lighting
LED165/M400/740 Tether Kit
BEFORE YOU BEGIN
STOP
Read these instructions completely
and carefully. Save these instructions
for future use.
!
WARNING
Risk of electrical shock. Disconnect power before servicing
or installing product. Properly ground electrical enclosure.
WARNING
!
Check the ballast information. Make sure the ballast is in
GE's ballast compatibility list. Using with wrong ballast may
result in overheat or lamp damage. See ballast compatibility list
at:
http://www.gelighting.com/led-hid-ballast-compatibility
CAUTION
!
Risk of injury or damage. Unit will fall if not installed properly.
Follow installation instructions.
CAUTION
!
Risk of injury. Wear safety glasses and gloves during
installation and servicing.
Tools and Components Required
• Nut driver or small socket wrench
Warning:
Only use the parts provided with the kit.
Please contact GE at 1-800-338-4999 for any questions/issues regarding the kit.
Installation Guide
Advertisement
Related Manuals for GE Lighting LED 165
Summary of Contents for GE Lighting LED 165
-
Page 1: Before You Begin
Lighting Installation Guide LED165/M400/740 Tether Kit BEFORE YOU BEGIN STOP Read these instructions completely and carefully. Save these instructions for future use. WARNING Risk of electrical shock. Disconnect power before servicing or installing product. Properly ground electrical enclosure. WARNING Check the ballast information. Make sure the ballast is in GE’s ballast compatibility list. -
Page 2: Parts List
LED165/M400/740 Tether Kit Installation Guide Parts List: • 1 Steel Ring • 1 U-shape rod 2 mounted nuts • 3 High Temperature Lock Nuts (1 extra nut is provided for your convenience) • 1 Tether Kit includes: 1 tether wire (2m), 1 locker, 1 hook Instructions: Step 1. - Page 3 LED165/M400/740 Tether Kit Installation Guide Warning: Check the status of the E39 socket. Poor condition of the socket may result in electrical shock, overheat or lamp damage. If the socket shows signs of corrosion or arcing as shown in the pictures, replace the socket and the lamp (if it shows damage) GOOD Socket DAMAGED Socket...
- Page 4 LED165/M400/740 Tether Kit Installation Guide Correct Assembly: WRONG Assembly: U-shape rod Wings of steel ring over the LED area NOT pointing away from the base Step 5 Hook the tether to either wing hole on the Steel ring. Step6 Screw the LED lamp with the mounted kit into the fixture.
- Page 5 Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions. GE Lighting and GE Lighting Solutions, LLC are businesses of the General Electric Company. © 2016 GE.