Integra DTM-7 Instruction Manual page 6

> Before Start > Part Names

Rear Panel
1. DIGITAL IN OPTICAL/COAXIAL jacks: Input TV or AV component digital audio signals
with a digital optical cable or digital coaxial cable.
2. ETHERNET jack: Connect to the network with an Ethernet cable.
3. USB jack: A USB storage device is connected so that music files stored in it can be
played. You can also supply power (5 V/500 mA) to USB devices with a USB cable.
4. Wireless antenna: Raise for Wi-Fi connection or when using a BLUETOOTH wireless
technology enabled device. Adjust their angles according to the connection status.
5. TUNER AM/FM 75≠ terminals: The supplied antennas are connected.
6. HDMI OUT jack: Connect a HDMI cable to transfer video signals and audio signals to a
TV.
7. HDMI IN jacks: Input video signals and audio signals with a HDMI cable connected to an
AV component.
6
> Install > Initial Setup
    
   
> Playback
    

8. REMOTE CONTROL jack: An Onkyo product with RI jack can be connected and
synchronized with this unit (P13).
9. IR IN/OUT terminals: Connected to the multi-room remote control kit. (*)
10.12V TRIGGER OUT A/B jacks: Allows you to connect a device with 12V trigger input jack
to enable link operation between the device and the unit (P40, 41). (*)
11. RS232 port: For connection to the home control system. (*)
(*)Special devices or cable connections are necessary to use the control functions 9 to 11.
Contact the specialized stores for more information.
12.AC INLET: Connect the supplied power cord.
13.GND jack: The ground wire of the turntable is connected.
14.AUDIO IN jacks: Input AV component audio signals with an analog audio cable.
15.ZONE 2 LINE OUT jacks: Output audio signals with an analog audio cable to a pre-main
amplifier in a separate room (ZONE 2).
16.SUBWOOFER PRE OUT jacks: Connect a powered subwoofer with a subwoofer cable.
Advanced Setup | Supplementary Information | Others
 
90°

180°