Controller Connection - Hyundai DS-9600 Quick Operation Manual

Quick Operation Guide of DS-9600/8600/7700/7600 Series NVR

Controller Connection

To connect a controller to the NVR:
1. Disconnect pluggable block from the KB terminal block.
2. Unfasten stop screws from the KB D+, D- pluggable block, insert signal cables into slots and fasten stop
screws. Ensure signal cables are in tight.
3. Connect Ta on controller to D+ on terminal block and Tb on controller to D- on terminal block. Fasten stop
screws.
4. Connect pluggable block back into terminal block.
Note: Make sure both the controller and NVR are grounded.
18