Philips DVP620VR/00 Service page 245

www.freeservicemanuals.info
Main 7/8 Schematic Diagrams < VCR Section >
" " = SMD
Voltage indications for PLAY, REC and DVD modes
on the Schematic Diagrams are as shown below:
1 2 3
~
5.0
THE SAME VOLTAGE FOR
INDICATES THAT THE VOLTAGE
PLAY,REC & DVD MODES.
IS NOT CONSISTENT HERE.
CAUTION !
For continued protection against fire hazard,
replace only with the same type fuse.
PLAY MODE
5.0
REC MODE
(2.5)
DVD MODE
< >
0
NOTE :
The voltage for parts in hot circuit is measured using
hot GND as a common terminal.
1-12-19
CAUTION !
Fixed voltage ( or Auto voltage selectable ) power supply circuit is used in this unit.
If Main Fuse (F1001) is blown, check to see that all components in the power supply
circuit are not defective before you connect the AC plug to the AC power supply.
Otherwise it may cause some components in the power supply circuit to fail.
1-12-20 H9723SCM7