Changing A Fabric Ribbon; Remove A Fabric Ribbon Cartridge - IBM Selectric Operating Instructions Manual

ribbon reverse lever
'
lever
ribbon position

Changing a Fabric Ribbon

Your fabric ribbon
will provide longest
the position the Ribbon Lever
of Left
if
changed frequently. This allow the ribbon
will
these
to re-ink itself during changes. The
first setting, the right, used
is
on
stencils. Settings two, three and four move the
to the top, middle or bottom
typing line
the ribbon. wish to reverse
portions of
If you
the direction which the ribbon
in
move the Ribbon Reverse Lever to the oppo-
site side. This done automatically when
is
either side the cartridge becomes empty.
of
Note:
To prevent drying out, keep ribbons
containers ready to use.
in until
25
Remove
To
a
. Centerthe
life Carrier and then turn the motor
is the front cover.
- Lift
Keep the Paper
-
the Ribbon Change Lever to the far
Move
-
for right. This
typing will
easier
removal
is winding,
Fabric Ribbon Cartridge
Off.
against the platen.
Bail
raise the Ribbon for
Lifts
the ribbon.
of
the cartridge upward and
off
Lift
-
Cartridge Spindles.
Ease the ribbon out the slots
of
-
Ribbon
Lifts.
rewind excess ribbon, insert a pencil
To
-
either the holes the base
of
in
cartridge and turn the direction
in
the arrow.
the Ribbon
the
in
in
the
of
of