Changing Typing Elements; Ribbon/Stencil Control; Film Ribbon Typewriter - IBM Selectric II Operating Instructions Manual

Changing Typing Elements
To remove an Element
• Be sure the typewriter is in Iowercase Posi-
t i o n , i.e., the triangle on the Typing Ele-
ment points toward the platen.
• Lift the element release lever until the
lever clicks into position.
• Remove the Element, grasping it by the
element release lever and lifting it off the
element post.
To replace an Element
• Be sure the typewriter is in Iowercase
Position; i.e., the shift lock key is not
depressed.
• Grasp the element release lever and
place the Typing Element on the ele-
ment post w i t h the triangle pointing
toward the platen.
• Lower the element into place on the
element post and close the lever.
.
Ribbon/Stencil Control
Film Ribbon Typewriter
Regulär typing: Set The Ribbon Control
at position R for regulär typing. This may
be done by pushing the button on the
control, if not already at R. This auto-
matically moves the Control to the print-
ing position.
Stencil typing: To type stencils move the
Control to the left so the S lines up under
the red mark and locks into that position.