AEG X91484MG1 User Manual page 6

6 www.aeg.com
Maintenance of the remote control
Cleaning the remote control:
Clean the remote control with a damp cloth
and a neutral solution of detergent without
abrasive substances.
Changing the battery:
• Open the battery casing located on the
rear side (magnet fi xing).
• Change the fi nished batteries with new
one type CR 2032 3V
In inserting the new battery respect the
polarity indicated on the battery casing!
• Close the battery casing up again.
Disposal of the batteries
Ultimate disposal of the batteries should be
handled according to all national laws and
regulations. Do not place used batteries in
your regular waste. Ultimate disposal of the
batteries must be done safely.
Contact your local waste management
offi cials for other information regarding the
environmentally sound collection, recycling,
and disposal of the batteries.
Built-in Push Button Functions
Press the right side to switch ON and OFF
the lights
Press the left side to select the suction
speeds available.
Grease Filter saturation indicator
Perform grease fi lter maintenance as the
corrisponding control led
Reset of the Grease Filter saturation
indicator
Press the built in Push Button
than15 secs.
6. LIGHTING
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the technical
service.
light on.
1 for more
Caution! Do not look directly into the
LED light.