Introduction Your new waste disposal has been manufactured to the highest possible standards. It is designed to be simple to operate, and require minimal maintenance. Operation of the appliance will depend on the type of installation detailed later in this manual. If you have any questions, please do not hesitate to contact us using the numbers located in the rear of this manual.
Installation, Use and Care. Thank you for choosing an Ikon Food Waste Disposer. Please follow the installation instructions ensuring adherence to local bylaws. Correct installation is vital in ensuring the product performs to the best of its ability. Failure to adhere to these instructions may invalidate your warranty.
Product Application The Ikon Food Waste Disposer is designed to grind excess food waste into fine particles which are then flushed through the standard waste attached to the kitchen sink. Due to the large range of items that can be placed into the disposal, below is a sample of products that can be placed into the disposal.
Important Safety Information This appliance is not intended for use by children or mentally / physically infirm persons, or those who are lack of knowledge and/or experience of similar products, unless under proper supervision by their guardians. DO NOT place fingers inside the appliance! BEFORE servicing the appliance physically disconnect the power supply.
Installation While reading the installation instructions, please also make reference to the diagram on page 8. Also note that once installed, the reset button and any reversing switches must be readily accessible. Separate the hopper from the Mounting Ring by turning the Mounting Ring in a clockwise direction.
Page 7
If your appliance came complete with an IKON Air Switch, install the control button in your sink top by using a 33mm chassis punch to punch a hole in the stainless steel. Place the top of the chrome plated switch through the hole and hand tighten the nut.
Correct Usage Operating your Food Waste Disposer could not be easier: 1. Turn on the cold tap. (Flow rate should be a minimum of 4L per minute) 2. Turn on the appliance. 3. Place product to be disposed of into the appliance, use the provided plug to assist in pushing the scraps into the appliance if necessary.
Detailed Product Information HP(W) Volt Amp Hz RPM Time Weight Insulation (min) (KG) Rating 220- 3.25 50 2600 (3/4 HP) 220- 50 2600 (1 HP) 1. Waterproof device is fixed between the motor and grinding mechanism. 2. The “Quick Lock” device allows for easy quick installation/removal.
Please be aware that in the event of a warranty call for a faulty installation or user fault, you will be charged as this is not covered under the manufacturer’s warranty. To contact us please call 0800 83 83 84 Ikon Commercial Ltd...
In the unlikely event this product requires servicing within this period, please contact the supplier listed below. Proof of purchase will be required. To make a warranty claim, please contact directly to: Ikon™ Commercial Limited PO BOX 15158 Dinsdale, Hamilton...
Page 13
(the Product) shall be free from manufacturing defects in materials or workmanship for a period that is agreed at the time of purchase from the date of original purchase of the product from IKON or from the retailer (as the case may be).
Page 14
The Product has been dismantled, repaired or serviced by other than an authorised IKON service person. 5. A claim under this warranty is not notified in writing to IKON within a reasonable period after the defect in the Product would have become apparent to a reasonable person.