Table of Contents
Advertisement
Diagnostics
Error Indication (Error is indicated by a flashing message)
No.
ON SCREEN
CAUSES
METHODS OF CORRECTION
®
ERROR-2
When trying to enter the same satellite
name/No. into memory at more than one
satellite position.
Press 1 ENTER again to cancel the error,
i
The satellite is stored at the new position.
ERROR-3
When trying to enter more than two
satellite into memory at one single satellite
position.
Except it one is C Band and the other Ku
Band.
Press 1 ENTER 1 again to cancel the error.
The priority is given to the name of the
new satellite.
ERROR-6
When feedback pulses are not being
received.
A. When the actuator is fully extended or
retracted in the initialize mode or in the
manual mode.
B. When the actuator is not correctly
connected with the receiver, the
connection is broken, (no pulse being
received) or a defective position sensor.
Press [e] / [^ to move the antenna
position slightly in the reverse direction.
Check that antenna is not into a stop, or
that cable connections to actuator are
secure.
@
ERROR-8
"ERROR-2" and "ERROR-3" occurred
simultaneously. (The same satellite name
was tried to be stored at the same antenna
position.)
Press ICANCELl.
This information has been already stored.
(D
ERROR-!
Memory error
4
Turn the power off and call your dealer.
-35-
Advertisement
Table of Contents
