In using this product you take full responsibility for its proper use. Factor Electronics, authorized Factor Electronics distributors and re-sellers are not responsible for any breach of privacy laws which may arise from your use of this product.
IMPORTANT NOTE: THIS OWNER'S MANUAL IS PROVIDED AS AN INSTALLATION AND OPERATING AID. FACTOR ELECTRONICS DOES NOT ASSUME ANY RESPONSIBILITY AS TO ITS ACCURACY AND SHALL NOT BE LIABLE IN TORT OR CONTRACT FOR ANY DIRECT, CONSEQUENTIAL OR INCIDENTAL LOSS OR DAMAGE ARISING FROM THE INSTALLATION, USE OR INABILITY TO USE THIS PRODUCT.
Page 3
The COMM-2 also provides electronically balanced inputs and outputs and can be used for a wide variety of talk/listen audio installations. The COMM-2 is a complete two way audio system providing a high power “Class D” amplifier, re-entrant horn speaker and microphone in a weather resistant enclosure.
Page 4
COMM-2 is connected to the camera you can initiate the talk listen features of the COMM-2. 2. When the COMM-2 is connected to a camera system the unit will be in listen mode. The COMM-2 will provide audio monitoring of the installation site. The COMM-2 will automatically switch to talk mode when a page is initiated from the monitoring station through the IP camera system.
Page 5
2. The COMM-2 includes 2 x shielded unbalanced 3.5mm male to male 6' cables and 2 x balanced 3.5mm female input/output connectors wired as follows: Balanced 3.5mm connection:...
Page 6
Pin 3 - G Sleeve 6. Please see the example below where the COMM-2 is being added to an existing audio system in a large building and used for two way communications without an IP camera. A single COMM-2 can provide both talk and listen audio functions.
Page 7
4. Loosen the “ Angle adjustment wing nut” to approx 75% but do not remove the wing nut. Push the wing nut to release the wing bolt. Now the COMM-2 will rotate. Rotate to the desired angle and tighten the “Angle adjustment wing nut”.
Page 8
Warranty The Factor Electronics COMM-2 is warranted to be free from defects in workmanship and materials for a period of (1) year from the date of purchase without charge for parts or labor.