EasyChef EC24 Manual page 5

1) Connect the gas regulator to the gas supply line
(down stream from the shut off valve). The
regulator inlet is marked by the "IN" or an arrow
showing direction of gas flow.
2) Connect a 3/8" stainless appliance connector to
the gas supply line (down stream from the shut off
valve) (figure 3).
3) Route connector by turning a complete spiral loop
with connector outlet facing forward.
4) Slide grill head into opening and attach the
connector to gas inlet manifold on right rear.
5) Make certain all burner knobs are turned to the
"OFF" position. Turn main gas shut-off valve to
the "ON" position. Check all connections to the
grill by brushing on a 50/50 soap and water
solution. If any bubbles are noted, tighten
connection and re-check.
WARNING: Never check for leaks with an open flame.
6) Slide the grill back into position watching the
connector does not "kink" in the process (excess
stainless connector may be located under grill).
For further information GO TO "Component Assembly."
Figure 3 - Gas Connection
CART, PEDESTAL, POST ASSEMBLIES
The EasyChef Grill may be assembled on one of the
following mountings available from your local dealer:
DESCRIPTION
Deluxe Cart
Pedestal Cart
Patio Base
Permanent Post
Follow the assembly instructions included with the
above-mentioned mounting assemblies. In-ground post
assemblies should be protected against corrosion as
warranted by soil conditions. For further information
check the Permanent Post instruction.
EC24 P/N EC30 P/N
10655 10565
10656 10592
10757 10756
10657 10567
COMPONENT ASSEMBLY
Now that your EasyChef Grill is properly mounted, there
are only a few short steps necessary to complete your
grill.
EGS - EasyChef Grill System:
1) Remove packing from the Stainless flame baffles.
Turn baffles at an angle and drop into the chassis.
Align the baffle, (4) tabs fore and aft for proper
position (figure 4).
Figure 4 - Baffle Placement
.2) Open bag of ceramic briquettes. Position
briquettes on each of the baffles as shown in
(figure 5).
Note: There are (14) briquettes on the (5) baffles for the
EC30 for a total of (70) briquettes.
The EC24 has (11) briquettes on each of the (4) baffles
for a total of (44) briquettes.
3) Install (2) of the stainless grids onto the top
mounting rails.
Figure 5 - Briquette Placement
4) Install the grease tray under the control panel
onto the slides.
5