Assemble Extension Bar/Roller Bar Locking; Mounting The Power Tool - PowerTec UT1004 Owner's Manual

ASSEMBLE EXTENSION BAR/ROLLER BAR
LOCKING KNOBS
Refer to Figure 4, 5
The two extension bars can be assembled in the
extension bar brackets found at the right and left of the
stand.
Figure 4
Extension
Extension
Bar Bracket
Bar
Pan Head Screw
Locking Knob
• Slide the extension bar into the extension bar bracket.
Insert the pan head screw into the hole in the end of
extention bar.
• Slide the extension bar in or out to desired location and
secure in place with locking knob.
• Place the roller arm into the roller bar support, slide up
and down to desired location and secure in place with
large locking knobs.
Figure 5
Locking Knob
ASSEMBLY
Extension
Bar Bracket
Roller Bar
Roller Bar Support

MOUNTING THE POWER TOOL

WARNING
Risk of accidental starting and serious personal injury.
Unplug the power tool before attaching it to the ultra-work
stand.
WARNING
Risk of serious personal injury. Always make sure the
power tool is fully supported and securely attached to
a level work surface. Make sure the ultra-work stand is
located on a flat surface.
IMPORTANT: Use the mounting hardware supplied to
mount the power tool to the ultra-work stand. Always
insert the bolt from the bottom of the ultra-work stand.
Secure at all four feet of the power tool.
• Place the tool to be used on the table top.
• Move the tool around until the hole pattern matches
the slot combination on the table top, secure with the
mounting hardware supplied.
• Insert the bolt through the bottom of the table and
secure with flat washer, lock washer and nut.
Figure 6
3
3
Nut
Lock Washer
Flat Washer
Bolt