Table of Contents
Advertisement
2
UNPACKING
Refer to Figure 1
Check for shipping damage. Check immediately whether
all parts and accessories are included.
ITEM DESCRIPTION
A
Ultra-work stand
B
Extension bars
2
C
Roller bars
D
Locking knobs
E
Handle
F
Screws and lock nuts (handle)
G
Power tool mounting hardware
(mounting bolt, washer, lock washers and
nut)
H
Pan head screws
Figure 1
A
C
B
WARNING
Do not use the ultra-work stand until it is completely
assembled and you have read and understood this entire
operating manual and the operating manual of the tool
being used with this ultra-work stand.
WARNING
Do not use the ultra-work stand for scaffolding or as a
ladder. Make sure to securely tighten all fasteners before
using. Maximum capacity is 330 lbs. (150 kg). Power tools
on the ultra-work stand should not exceed a combined
overall height of 60" (152.4 cm) from the floor.
F
E
D
G
ASSEMBLY
TOOLS NEEDED
The following tools (not included) are needed to assemble
the ultra-work stand:
Phillips head screwdriver
QTY
10 mm open end wrench
1
2
UNFOLD THE WORK LEGS
2
Refer to Figure 2
4
1
• Place the ultra-work stand on a flat surface with the
2
folded legs facing up.
4
• Depress the leg release spring pins and rotate the leg
until it clicks and locks into the open position. Repeat for
each leg.
2
Figure 2
Leg
H
• Place the ultra-work stand in the upright position on a
flat surface.
ASSEMBLE HANDLE
Refer to Figure 3
• Secure handle to frame with hardware supplied.
Figure 3
Lock Nut
Leg Release
Spring Pins
Handle
Screw
Advertisement
Table of Contents
