Connecting The Equipment; Safety Precautions And Guarantee - Prodipe TT100 Solo User Manual

Connecting the equipment

Power supply for the receiver:
Plug the mains adaptor into the back of the receiver (designated slot) and connect to a 220-
230V/50Hz mains socket.
Audio Connection:
Connect the audio lead from the audio output (jack or XLR socket) of the receiver to your
amp or mixing deck.
Safety precautions and guarantee conditions
•
If you put your hand over the mic mesh or if it is placed too close to the mouth, you may
have feedback problems. First make sure you lower the volume, then move the mic
slightly away from the mouth.
•
Foreign particles and dust may clog the mesh/filter and affect the mic's frequency
response. The mesh should be regularly removed from the mic, cleaned with warm soapy
water, rinsed with clear water, dried and fitted back onto the mic.
•
Your mic diaphragm is very sensitive. Please avoid dropping the mic or handling it roughly.
•
To ensure optimum sensitivity and sound quality, please avoid using your mic in damp
conditions or in extreme temperatures e.g. strong sunlight.
Prodipe and its distributors decline all responsibility for any damage caused to the unit in
the event that the above safety precautions are not followed.
Illustrations et photos non contractuelles
Copyright © 2013 IPE Music
-22-