Advertisement
Quick Links
Download this manual
See also:
Instructions for Using
Octagon 20 Parrot Rearing Module
for brooding Parrots and other altricial bird species
Contents
Section
1
2
3
4
5
6
7
8
9
User instructions
Subject
1
PRM GB Issue 2
Page
2
2
3
3
4
5
5
5
6
Advertisement
Related Manuals for Brinsea Octagon 20
Summary of Contents for Brinsea Octagon 20
-
Page 1: Table Of Contents
PRM GB Issue 2 Octagon 20 Parrot Rearing Module for brooding Parrots and other altricial bird species User instructions Contents Section Subject Page Introduction Unpacking Location and Installation Temperature Humidity Introducing your birds Cleaning up Servicing Specifications... -
Page 2: Introduction
Damage to these parts could cause injury or death to a bird. The Octagon 20 PRM can be ordered as an accessory to the Octagon 20 Digital incubator (excluding incubator top) or as a complete independent brooder (including incubator top). -
Page 3: Location And Installation
2.4 Complete and return your guarantee card to register for your free 2 year guarantee. 2.5 Go to www.Brinsea.co.uk and register as a free member of the Brinsea e-mail group to receive the latest news and information such as advance notice about new products, special offers, exclusive competitions and much more. -
Page 4: Humidity
Octagon 20 incubator and PRM. Contact Brinsea or your local dealer for details. 5.3 The Brinsea H22 Automatic Humidity Management Module is available as an option on the Octagon 20 incubator and PRM. This module provides a readout of RH level and automatically controls water evaporation... -
Page 5: Introducing Your Birds
DO NOT USE A DISHWASHER TO CLEAN THE TRAY, BASE OR INCUBATOR LID. 7.2 Following each brood in your Octagon 20 PRM remove all debris from the floor. Wipe all internal surfaces with a soft cloth soaked in 100:1 Brinsea Incubation Disinfectant solution. Immerse and soak the tray in disinfectant solution. -
Page 6: Specifications
8.3 The digital temperature display is individually calibrated during manufacture but may be re-calibrated if required. To ensure optimal performance return the incubator to Brinsea Products Service dept. for re- calibration every two years. It is not recommended that this procedure is carried out by the user.