Table of Contents
Advertisement
HOT GAS REHEAT OPTION
Are uncontrollable humidity problems
costing you a bundle?
Why put up with humidity problems
when you can have true climate control
with the installation of an FHP water
source heat pump with the
Reheat Option (Humidimiser option).
When your FHP unit contains this
Underwriters Laboratory (UL) approved
optional feature...your normal air conditioning
cycle converts, as required, to an air drying operation.
Your FHP unit with the
provide cooling, heating, and dehumidi cation by
setting our combination thermostat/humidistat control.**
This option is available on the full range of FHP products.
This option is ideal for any application where a high level
of dehumidi cation is required. Typical applications are:
Indoor Pool Areas*
Outside/Make-Up Air Applications**
Computer Rooms
Hotel rooms during non-occupancy
* Note: Special coil and/or cabinet coating may be necessary
** Note: Cooling always takes priority over dehumidi cation.
ISO 9001: 2000 Certified
FHP MANUFACTURING COMPANY
601 N.W. 65TH COURT • FT. LAUDERDALE, FL 33309 • PHONE: (954) 776-5471 • FAX: (800) 776-5529
http://www.fhp-mfg.com
Hot Gas
Humidimiser
option will
heat pumps
970-196 Rev. 10/04
Advertisement
Table of Contents
Related Manuals for FHP HR000
Summary of Contents for FHP HR000
- Page 1 This option is available on the full range of FHP products. This option is ideal for any application where a high level of dehumidi cation is required. Typical applications are:...
- Page 2 HEAT RECOVERY PACKAGE Table of Contents Model Nomenclature ....................1 Inspection..........................2 Application........................2 Field Mounting HR ......................2 Water Tank Preparation ....................3 HR Water Piping.......................3 Typical Installation......................3 Water Tank Refill......................4 Installation Start-Up.......................4 Trouble Shooting ......................4 Electrical Diagram......................4 Capacity Data ........................4 MODEL NOMENCLATURE 208/230-1-60 HEAT RECOVERY PACKAGE HEAT EXCHANGER...
- Page 3 HEAT RECOVERY FORWARD: based on reduced loads thus the ability to heat hot water is also reduced. This same result could be noticeable on units The complete instruction manual should be read carefully that are over sized for the served loads thus resulting in before beginning installation.
- Page 4 HEAT RECOVERY TYPICAL CONNECTION DIAGRAM FOR EM/EC SERIES TYPICAL CONNECTION DIAGRAM FOR EV/ES, AU, AP, GT/GS SERIES WITH INTERNAL HRP (Figure #3) Cut the hot gas discharge line between the compressor Once drained the tank should be flushed with cold water discharge port and the reversing valve inlet.
- Page 5 Scaled or fouled heat exchanger CAPACITY DATA LINE VOLTAGE CONTROL DIAGRAM POTENTIAL NOMINAL HR CAPACITY GHR GPM MODEL SAVINGS PER HOUR UNIT TONS (BTU/HR.) FLOW RATE EQUIV. - Kwh 1,430 HR000 2,140 2,858 HR001 4,287 5,716 1.00 7,146 1.25 HR002 8,575 1.50 10,004 1.75 11,433 2.00...
Need help?
Do you have a question about the HR000 and is the answer not in the manual?
Questions and answers