1. Manuals
  2. Brands
  3. Cornelius Manuals
  4. Juicer
  5. QUEST ELITE 4000
  6. Installation manual

Cornelius QUEST ELITE 4000 Installation Manual

Hide thumbs Also See for QUEST ELITE 4000:
Table of Contents

Advertisement

Quick Links

See also: Service Manual
QUEST ELITE 4000
Installation Manual
Release Date: December 10, 2010
Publication Number: 620048956INS
Revision Date: August 30, 2016
Revision: G
Visit the Cornelius web site at www.cornelius.com for all your Literature needs.

Advertisement

Table of Contents
loading

Related Manuals for Cornelius QUEST ELITE 4000

Summary of Contents for Cornelius QUEST ELITE 4000

  • Page 1 QUEST ELITE 4000 Installation Manual Release Date: December 10, 2010 Publication Number: 620048956INS Revision Date: August 30, 2016 Revision: G Visit the Cornelius web site at www.cornelius.com for all your Literature needs.
  • Page 2 Commercial Warranty. Cornelius will not be responsible for any repair, replacement or other service required by or loss or damage resulting from any of the following occurrences, including but not limited to, (1) other than normal and proper use and normal...

  • Page 3: Table Of Contents

    Quest elite 4000........

  • Page 5: Safety Instructions

    Quest Elite 4000 Installation Manual SAFETY INSTRUCTIONS OLLOW AFETY NSTRUCTIONS Safety Overview ALL SAFETY INSTRUCTIONS • Read and follow in this manual and any warning/caution labels on the unit (decals, labels or laminated cards). • Read and understand ALL applicable OSHA (Occupational Safety and Health Administration) safety regula- tions before operating this unit.

  • Page 6: Qualified Service Personnel

    Quest Elite 4000 Installation Manual UALIFIED ERVICE ERSONNEL WARNING: Only trained and certified electrical, plumbing and refrigeration technicians should service this unit. ALL WIRING AND PLUMBING MUST CONFORM TO NATIONAL AND LOCAL CODES. FAILURE TO COMPLY COULD RESULT IN SERIOUS INJURY, DEATH OR EQUIPMENT DAMAGE.

  • Page 7: Requirements

    High side 400 psi (2757.9 kilopascals), (27.6 bar). Low side 88 psi (606.7 kilopascals), (6.1 bar). Model Quest ELITE 4000, 230 VAC, 2 amps, 1 phase 50 hertz, 6.34 - 6.41 oz. (180-182g) R-134a refrigerant. Test press: High side 400 psi (2757.9 kilopascals) (27.6 bar). Low side 88 psi (606.7 kilopascals), (6.1 bar).

  • Page 8: Power Supply

    Quest Elite 4000 Installation Manual Power Supply 15 amps at 120 volts dedicated power supply. 10 amps at 230 volts dedicated power supply. Water Connection 3/8 in. (0.95 cm) SAE male flare fitting on dispenser (Figure 3). Water Connection Figure 3. Water Connection Water Supply Requirements 60 psi (413.7 kilopascals) (4.1 bar) maximum static pressure.

  • Page 9: Applications

    Quest Elite 4000 Installation Manual APPLICATIONS This appliance is intended to be used in household and similar applications such as the following: • Staff kitchen areas in shops, offices and other working environments. • Farm houses and by clients in hotels, motels and other residential type environments •...

  • Page 10: Receiving

    Quest Elite 4000 Installation Manual RECEIVING Each unit is completely tested and inspected before shipment. At the time of shipment, the carrier accepts the unit and any claim for damage must be made with the carrier. Upon receiving the unit(s) from the carrier, inspect the carton for visible damage. If damage exists, have the carrier make a note on the bill of lading and file a claim with the carrier.

  • Page 11: Counter Location

    Quest Elite 4000 Installation Manual COUNTER LOCATION Select a location in a well ventilated area, close to a grounded electrical outlet. If possible do not place the unit close to hot and/or steaming machines. INIMUM IRFLOW LEARANCE The minimum airflow clearance is: 4” (10.16 cm) in back and 12” (30.48 cm) on top and open to the front.

  • Page 12: Filling The Ice Bath

    Quest Elite 4000 Installation Manual FILLING THE ICE BATH The ice bath holds approximately 3.5 gallons (13.4 liters) of water. The fill tube is located behind the front splash plate and capped with a 0.5” plug. Remove the 0.5” plug and attach the tube to any one of the dispense nozzles.

  • Page 13: Connecting The Water Supply

    Quest Elite 4000 Installation Manual CONNECTING THE WATER SUPPLY The Quest Elite series Juice Dispenser is designed to dispense juice at a high flow rate. It is very important that the incoming water line be dedicated for use by the dispenser only and does not have other machines connected which could cause a water surge, (i.e., a dishwasher, coffee maker, etc.).

  • Page 14: Priming/Flushing Water System

    Quest Elite 4000 Installation Manual PRIMING/FLUSHING WATER SYSTEM To properly prime the unit with water and remove air pockets in the system, open the cabinet door and make sure that all the valve levers are in the Dispense position. Close the door and press the dispense button for a few seconds. Repeat until a steady flow of water is observed from all dispense valves.

  • Page 15: Programming The Portion Control

    Quest Elite 4000 Installation Manual PROGRAMMING THE PORTION CONTROL If the dispenser has optional portion controls, they have been pre-programmed from the factory to pour 7, 12, and 16 ounce drinks. The “extra large” (pitcher icon) size has also been pre-programmed to pour 16 ounces.
  • Page 16 Quest Elite 4000 Installation Manual Publication Number: 620048956INS - 12 - © 2010-2016, Cornelius Inc.
  • Page 18 Cornelius Inc. www.cornelius.com...

Table of Contents