Instructions - Nutrifaster Ruby2000 Mk iii User Manual

INSTRUCTIONS:

Follow these instructions for safe, trouble free juicing.
STEP .
Upon unpacking your juicer perform an initial inspection.
1
Make sure that the juicer is free of dam- age that
may have occurred during transport, and that all parts
have been supplied.
Your box should contain the following items
 1 x Ruby 2000 juicer
 1 x Exhaust Tube
 1 x 7/8 combination spanner/wrench
 1 x Pusher / Plunger
 Envelope containing User's Manual & Warranty Card
STEP
Fill in the warranty card and return to our office within
2.
7 days of purchase.
STEP
It is now time to look for a place to set up your juicer.
3.
 We recommend a working area of approximately 500mm x 500mm.
 You also require a 220 V, 10 amp Power supply.
 The Ruby 2000 MkIII has 8 positions for the juice spout and 2 for the
exhaust tube, making it suitable for most locations.
STEP
Once you have found a suitable location for your juicer remove the top cover.
4.
You should see the 7/8 locking nut that holds the cutting blade and strainer in
place. Loosen this with your wrench removing it along with the strainer, blade
and collection pan. Locate the juice spout in the hole that best suits your
workspace. Replace the strainer making sure it locks into position over the 2
pins. Replace the blade, turning it till it locks into place. Replace the 7/8 nut,
tightening it firmly with your wrench.
STEP
5.
Replace the lid and fasten the lock latches on each side. These latches are adjustable.
To tighten the latches turn the hooks clockwise and to loosen them do the opposite.
Important - do not over-tighten the latches, this will stretch or break them.
STEP
6.
Plug in your juicer, making sure step 4 has been completed and the juicer is switched off.
You may now turn on the juicer. Your juicer should run smoothly.
STEP
7.
You are now ready to make your first juice.
(111)
(020)
(108)
;