Page 2
Trademarks Microsoft ® , Windows ® , and MS-DOS ® are registered trademarks of Microsoft Corporation in the United States and /or other countries. Other product names used herein are for identification purposes only and may be trademarks of their respective companies. We disclaim any and all rights involved with those marks.
2.3 LOAD PROGRAM................. UC5-4 2.4 TEST PAGE..................UC5-5 3. TROUBLESHOOTING ............UC5-6 3.1 TROUBLESHOOTING FLOWCHART ..........UC5-6 3.2 LED STATUS LIGHT SEQUENCE AND CONDITIONS ....... UC5-7 3.2.1 POWER ON AND ACTIVATION..........UC5-7 3.2.2 TEST PAGE BUTTON..............UC5-8 3.3 PRINTER DRIVER OPERATION............UC5-9 4.
Then install the printer driver in the host computer. Host computer IBM PC/AT compatible PC Interface IEEE1284B (Compatible, Nibble, ECP) Operating Systems Supported Windows 95/98/Me, Windows NT4.0, Windows 2000/XP Printer Driver Digital Duplicator A3 400 GDI C249I950.WMF UC5-1...
NOTE: This manual uses these symbols: Screw: # Connector: $ 2.1 CONTROLLER BOARD MEMORY C249R951.WMF [A]: Cover [B]: Keypad board NOTE: When you attach the connector [C] make sure to attach it in the correct direction and position [D]. UC5-2...
VIDEO I/F BOARD C249R952.WMF [A]: Connector [B]: Printer controller board [C]: SIMM module NOTE: The twisted portion of the harness [D] should fit loosely and close to the controller board. 2.2 VIDEO I/F BOARD C249R953.WMF [A]: Video I/F Board UC5-3...
7. Use COPY command to update the flash ROM. e.g. “copy file_name LPT1:” LPT1 is the connected port. C249R957.WMF 8. While the flash ROM is updating, the left LED [B] on the control button board is continuously on. C249R954.WMF UC5-4...
C249R958.WMF 2.4 TEST PAGE Press the test page button [A] on the keypad board. The right LED will start to flash quickly. This indicates that the controller is in the process of creating the test page. C249R954.WMF UC5-5...
Test page is ! Video Cable printed normal ! Video I/F Board ! Cable Printer Driver Is print test Setting, or result normal? Application Software Setting. Printed normal Printer Driver Fault with DOS Printer Port of Computer, Printer Cable C249T950.WMF UC5-6...
Left LED is flashing rapidly Receiving data Left LED is on continuously Transferring data Making a master Left LED is continuously off Idle • Check message on operation Left LED flashing slowly Error on engine and evenly panel. UC5-7...
• Check if the engine is online. • Check if SIMM card is positioned correctly. Left LED flashes slowly and Engine error • Check error message on the evenly. engine. • Check if the controller is properly connected to the engine. UC5-8...
8. Input “exit”. Then exit from the MS-DOS prompt or Command Prompt. 9. If the has printed correctly, return the printer driver to the previous printer port from port “File:”. 4. SERVICE TABLE There is no SP mode for printer controller unit. UC5-9...
Configuration IEEE1284 I/F 26-pin socket To IEEE1284 Interface Engine Interface 26-pin socket To video I/F board Power connector 4-pin socket To power cable SIMM Interface 72-pin SIMM For connecting the SIMM module Upgrade firmware jumper 2-pin Upgrading controller firmware UC5-10...
Windows 95/98/Me, Windows NT4.0 (*1), Windows 2000/XP Printer Driver Digital Duplicator A3 400 GDI *1: The Printer drivers for Windows NT4.0 are only for the Intel x86 platform. There is no Windows NT4.0 printer driver for the PowerPC, Alpha, or MIPS platforms. UC5-12...