Superior VD1824NM Installation And Operation Instructions Manual page 17

INSTALLING LOGS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only parts
specifi cally approved with this heater
may result in property damage or
personal injury.
CAUTION: After installation and
periodically thereafter, check to en-
sure that no fl ame comes in contact
with any log. With the heater set to
HI, check to see if fl ames contact any
log. If so, reposition logs according
to the log installation instructions in
this manual. Flames contacting logs
will create soot.
LVD18GO AND LVD24GO
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place rear log onto base. Holes in bottom
of log must seat over pins on base as
shown in Figure 18.
2. Place center log onto base. Holes in bot-
tom of log must seat over pins on base
as shown in Figure 18.
Center Log
Pin for
Hole in
Bottom
of Log
Figure 18 - Installing Rear and Middle Logs
(Picture may vary from actual)
126838-01C
INSTALLATION
Continued
3. Place front log onto grate as shown in
Figure 19. Front log has cut outs for the
fi ngers of the grate to fi t into.
Front Log
Grate
4. Place left crossover log as shown in Fig-
ure 20, Page 18. Match square peg on top
of center log with square hole on bottom
of left crossover log. Match pin on top of
front log with round hole on bottom of left
crossover log.
5. Place center crossover log as shown in
Figure 20, Page 18. Match square peg on
top of rear log with square hole on bottom
of center crossover log. Match pin on top
of center log with round hole on bottom
of center crossover log.
Rear Log
6. Place left front crossover log as shown in
Figure 20, Page 18. Log should rest on
the grate and fi t into recess area on the
center log.
Burner
SuperiorFireplaces.US.com
Figure 19 - Installing Front Log
(Picture may vary from actual)
17