Main Board - Sony CMT-G1BIP Service Manual

HCD-G1BiP/G1iP
2-6.

MAIN BOARD

Note 1: Refer to page 13 for wire setting.
qd flexible flat cable (9 core) (CN407)
Note 3: Both the flexible flat cable (9 core) can be
connected with the CN406 or CN407 on
MAIN board. When you connect the flexible
flat cable (9 core) with the CN407 on MAIN
board so as not to connect it by mistake.
0 connector
(CN805)
qa connector
(CN601)
9 Lift up the coating clip.
CN406
4 flexible flat cable (17 core)
(CN404)
qf two screws
(BVTP3
qg two coating clips
qj MAIN board
12
7 connector
(CN701)
qs flexible flat cable
(8 core) (CN401)
(G1BiP)
B
A
qf two screws
(BVTP3 8)
qh lug wire
qf screw
8)
6 Cut the binding band (taiton).
Note 2: In reassembling, use new binding
band (taiton) to fasten the clamp
same as before.
8 connector
(CN803)
B
A 1 flexible flat cable (21 core)
5 connector
(CN702)
3 flexible flat cable (15 core)
(CN403)
2 Lift up the coating clip.
Note 4: When you install the flexible
flat cable, please install them
correctly.
There is a possibility that this
machine damages when not
correctly installing it.
Insert is straight to the interior.
flexible flat
(BVTP3 8)
cable
connector
qh lug wire
Insert is incline
flexible flat
cable
connector
(CN401)
OK
NG