Panel (Front) Block - Sony CMT-G1BIP Service Manual

HCD-G1BiP/G1iP
2-4.

PANEL (FRONT) BLOCK

6 flexible flat cable (17 core)
5 Turn over the flexible
flat cable (15 core).
0 claw
– Rear side view –
Note 1: There is a possibility of damaged of the panel (CD tray) when the
panel (front) block is removed without removing the panel (CD tray).
Remove panel (CD tray) earlier than removing the panel (front) block.
The sleeve ferrite clamp must
come under the USB board.
sleeve ferrite clamp
JOG2 board
The wire must be on the
sleeve ferrite clamp.
– Front panel inner view –
front side
flexible flat
cable (17 core)
AMP board
flexible flat cable (15 core)
10
8 screw
(BVTP3 8)
(CN404)
4 Lift up the coating clip.
1 Lift up the coating clip.
USB board
HP board
coating clip
tape
tape
MAIN board
coating clip
9 two screws
(BV/ring)
3 connector
(CN601)
2 connector
(CN805)
0 claw
Note 2: When you install the panel (front) block,
put two sleeve ferrite clamps within this
dotted line range.
Note 3: Confirm the BD94D board has not dropped.
Note 4: When you install the flexible flat cable, please install them
correctly.
There is a possibility that this machine damages when not
correctly installing it.
OK
Insert is straight to the interior.
flexible flat
cable
connector
front side
coating clip
MAIN board
qa panel (front) block
8 screw
(BVTP3 8)
7 two screws
(BV3)
NG
Insert is incline
flexible flat
cable
connector
front side
CD mechanism deck