Suitable for newborn 18 kilograms group 0 + i (12 pages)
Summary of Contents for ebony convertible booster
Page 1
9 to 36 kilograms group I + II + III IMPORTANT: KEEP THIS BOOKLET IN THE PLACE PROVIDED ON THE CHILD RESTRAINT. Illustrations and designs may vary. follow us on the only choice...
Page 2
In order to protect your child correctly, the Mother’s Choice child safety seat must always be used and installed as described in these instructions. The fabric cover may be different to the illustrations shown in this instruction manual.
Page 3
Suitable for use only with a child weighing between 9-36kg. Only use this restraint with a vehicle fitting with a three point belt system, which conforms to UN/ECE 16 regulation or in accordance with similar regulation. Install the restraint on the passenger seat not equipped with airbag.
Page 4
Quick adjuster lever Quick adjuster strap Metal harness hook...
Page 5
Check the harness strap height, it must fit your child’s height. If not, please adjust harness strap height. 1. Press the quick adjuster lever with one hand, and then pull shoulder belt harness forward with other hand to loosen it.
Car seat installation convertible booster Group I(9~18kg) group I installation (9-18kg) Click “ ” 1. Pull out the vehicle seat belt, guide the vehicle seat belt pass through one side of belt guide on backrest place the lap belt pass through the base armrest below.
Page 7
I installation (9-18kg) Click “ ” 3. To unfasten the harness, release the buckle by pressing the red button inwards. Then pull the harness clips and put the harness straps aside.(See 6/7/8) 4.Place the baby into the restraint.(See 9) 5.Slide each harness strap over the child's shoulders.
Page 8
II + III installation (15-36kg) If using the safety seat in group II + III with backrest Operate as follows: 1. Pull out the metal harness hook from the back of the restraint, then remove the shoulder belt harness and the belt cover from the metal harness hook.
Need help?
Do you have a question about the convertible booster and is the answer not in the manual?
Questions and answers