English - Black & Decker bdl170b Manuel

ENGLISH

Intended use
This Black & Decker tool has been designed to project laser
lines to aid in DIY applications. This tool is intended for
consumer use only.
Safety instructions
Warning! When using battery-powered tools, basic safety

precautions, including the following, should always be
followed to reduce the risk of fire, leaking batteries,
personal injury and material damage.
Read all of this manual carefully before operating the tool.

Retain this manual for future reference.

Keep work area clean
Cluttered areas and benches can cause accidents.
Consider work area environment
Do not expose the tool to rain. Do not use the tool in damp or
wet conditions. Keep the work area well lit. Do not use the tool
where there is a risk of causing fire or explosion, e.g. in the
presence of flammable liquids and gases.
Keep children away
Do not allow children, visitors or animals to come near the
work area or to touch the tool.
Do not overreach
Keep proper footing and balance at all times.
Stay alert
Watch what you are doing. Use common sense.
Do not operate the tool when you are tired.
Use appropriate tool
The intended use is described in this instruction manual.
Warning! The use of any accessory or attachment or
performance of any operation with this tool other than those
recommended in this instruction manual may present a risk of
personal injury.
Check for damaged parts
Before use, carefully check the tool for damage. Ensure that
the tool will operate properly and perform its intended function.
Do not use the tool if any part is damaged or defective.
Store idle tools
When not in use, tools and batteries should be stored in a dry,
locked up or high place, out of reach of children.
Repairs
This tool complies with relevant safety requirements.
Repairs should only be carried out by qualified persons using
original spare parts; otherwise this may result in considerable
danger to the user.
Additional safety instructions for non-rechargeable
batteries
Warning! Batteries can explode or leak, and can cause injury
or fire. Observe the instructions as described below.
4
Carefully follow all instructions and warnings on the

battery label and package.
Always place batteries correctly according to the polarity

(+ and -) as marked on the battery and the product.
Do not short-circuit the battery terminals.

Do not attempt to charge non-rechargeable batteries.

Do not mix old and new batteries. Replace all of the

batteries at the same time with new batteries of the same
brand and type.
Keep batteries out of reach of children.

Remove batteries if the product will not be used for

several months.
Under extreme conditions, battery leakage may occur.

When you notice liquid on the batteries, proceed as follows:
- Carefully wipe the liquid off using a cloth.
Avoid skin contact.
Never attempt to open for any reason.

Do not store in locations where the temperature may

exceed 40 °C.
When disposing of batteries, follow the instructions given

in the section "Protecting the environment".
Do not incinerate the batteries.

Additional safety instructions for lasers
Read all of this manual carefully.
This product is not to be used by children under 16.
Warning! Laser radiation.
Do not look into the laser beam.
Do not view the laser beam directly with optical
instruments.
Refer to the laser product characteristics.
This laser complies with class 2 according to IEC 60825-1:

Ed 1:2001. Do not replace a laser diode with a different
type. If damaged, have the laser repaired by an authorised
repair agent.
Do not use the laser for any purpose other than projecting

laser lines.
An exposure of the eye to the beam of a class 2 laser is

considered safe for a maximum of 0.25 seconds.
Eyelid reflexes will normally provide adequate protection.
At distances over 1 m, the laser complies with class 1 and
thus is considered completely safe.