Ddc Key In Procedure; Install Software - ViewSonic VX1962wm Service Manual

5.3 DDC Key in Procedure

Note:
1. Every time after replacing the main board, you have to do the DDC key in.
2. If you find the DDC does not conform to the LCD monitor, you have to do the DDC key in.
5.3.1 Equipment Needed
- V1962wm/wmp-3
- PC (Personal computer)
LPT cable
-
- 12V DC
- Firmware upgrade program
DDC Card
-
- VGA Cable

5.3.2 Install software

You must install the
Note:
After installation, you must restart the PC to take the setup to effect.
5.3.3 Connect the DDC card as follow:
Connect this port to the VSC
V1962wm/wmp-3's VGA
12V Input
at the first.
26
Connect to the
PC LPT