Fcc Notices - Fujitsu LIFEBOOK A6120 SERIES User Manual

Hide thumbs Also See for LIFEBOOK A6120 SERIES:
Table of Contents

Advertisement

Changes or modifications not expressly
approved by Fujitsu could void this
user's authority to operate the
equipment.

FCC NOTICES

Notice to Users of Radios and Television
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet that is
on a different circuit than the receiver.
• Consult the dealer or an experienced radio/
TV technician for help.
Shielded interconnect cables must be employed
with this equipment to ensure compliance with
the pertinent RF emission limits governing this
device.
Notice to Users of the US Telephone Network
Your LifeBook notebook may be supplied with
an internal modem which complies with Part 68
of the FCC rules. On this notebook is a label that
contains the FCC Registration Number and the
Ringer Equivalence Number (REN) for this
iv
equipment among other information. If requested,
the user must provide their telephone company
with the following information:
1. The telephone number to which the
notebook is connected.
2. The Ringer Equivalence Number (REN) for
this equipment.
3. That the equipment requires a standard
modular jack type USOC RJ-11C which is
FCC Part 68 compliant.
4. The FCC Registration Number.
This equipment is designed to be connected to
the telephone network or premises wiring using
a standard modular jack type USOC RJ-11C
which is FCC Part 68 compliant and a line cord
between the modem and the telephone network
with a minimum of 26AWG.
The REN is used to determine the number of
devices that you may connect to your telephone
line and still have all of those devices ring when
your number is called. Too many devices on one
line may result in failure to ring in response to an
incoming call. In most, but not all, areas the sum
of the RENs of all of the devices should not
exceed five (5). To be certain of the number of
devices you may connect to your line, as
determined by the RENs, contact your local
telephone company.
If this equipment causes harm to the telephone
network, your telephone company may
discontinue your service temporarily. If possible,
they will notify you in advance. If advance notice
is not practical they will notify you as soon as
possible. You will also be advised of your right to
file a complaint with the FCC.
This fax modem also complies with fax branding
requirements per FCC Part 68.
Your telephone company will probably ask you
to disconnect this equipment from the telephone
network until the problem is corrected and you
are sure that the equipment is not malfunctioning.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents