Technical Data - Oras Ventura 8020 Installation And Maintenance Manual

INSTALLATION AND MAINTENANCE GUIDE

Technical data

Working pressure
Flow-rate at 300 kPa
Pressure loss
Noise class
Electrical connection
Protection class
Water temperature
Recognition range
Afterfl ow
Max. fl ow period
Dishwasher valve open period
Models
Oras Ventura kitchen faucet models:
– 8020: kitchen faucet with touchless faucet and dishwasher connection (see fi gure 1).
– 8025: kitchen faucet with touchless faucet and electronic dishwasher valve (see fi gure 2).
Installation of the faucet (see fi gure 3)
– Thread the socket (1) with the operating switch of the electronic dishwasher valve over the
installation aperture so that the switch points either to the right or to the left.
– Push the faucet in place into the installation aperture (ø 34 – 37 mm), then ensure that the sealing at
the base of the faucet or the socket is in place and that the wires from the faucet and the operating
switch do not get squeezed.
– Position the support plate (2) and tightening plate (3), and screw on the nuts (4) by hand. Turn the
touchless faucet to desired position and then tighten the nuts with a 9 mm wrench.
– Attach the inlet pipe of the touchless faucet's spout. Note! Left-hand thread in the inlet pipe.
Installation of the mixer unit
Figure 4
– Screw on the mounting plate (5) of the mixer unit at a suitable height.
– Hang the mixer unit to the holes of the mounting plate.
– Attach the faucet inlet pipes with their sealings to the mixer unit couplings according to the colour
codes.
Figure 5
– Insert the fi lters (6) to the PEX pipes and attach the pipes to the mixer unit couplings.
– Cut the pipes to a suitable length, insert the support sleeves (7) to the pipes and attach them to the
inlet pipes.
– Attach the sensor connector (8) to the right-hand side connector of the mixer unit.
Model 8020:
– If the connector (10) is used, remove the plug (11).
– If the connector (10) is used without a dishwasher valve, it does not meet the
requirements set for it in the Nordic countries.
Model 8025:
– If the connector (10) is used, remove the plug (11).
– Attach the dishwasher connector (9) to the left-hand side connector of the mixer unit.
– Connect the plug transformer to a wall socket.
– Open the water inlet to the faucet and check that the joints are tight.
100 – 1000 kPa
0.21 l/s
272 kPa at fl ow of 0.2 l/s
I (ISO 3822)
230/12 VAC (plug transformer)
IP 30
max. 80°C
preset 2 cm, range 0-6 cm (touchless faucet)
preset 3 s, range 1-10 s (touchless faucet)
preset 40 s (touchless faucet)
150 min., range 60 - 210 min/12h (in model 8025)
13
GB