Operation Instruction - KARUIZAWA KDH1816 User Manual

OPERATION INSTRUCTION

*Connect the power cord to the correct power supply.
1. ON/OFF button
Press the ON/OFF button to turn on the dehumidifier and the power indicator will be on. Press the
ON/OFF button again to turn off the dehumidifier and the power indicator will be off.
2. Humidity setting button
Press the humidity setting button to set the desired dehumidifying mode: continuous (CNT),
humidity 40%, 50%, 60% or 70%, and the relative mode indicator will be on.
3. Wind speed button
Press the wind speed button to set the wind speed. The high wind speed indicator will be on if high
wind speed is selected. The low wind speed indicator will be on if low wind speed is selected.
4. Timer button
Press the timer button in ON mode to set the auto off timer (1-24 hours) and the LED display will
show the set auto off time. The auto off timer will add 1 hour for each press. The LED display will
be returned to the room humidity after 8 seconds.
Press the TIMER in OFF mode to set the auto on timer (1-24 hours) and the LED display will
show the set auto on time. The auto on timer will add 1 hour for each press.
5. Temperature display button
Press the temperature display button and the LED display will show the room temperature .The
LED display will be returned to the room humidity after 8 seconds.
6. Dryer button
Press the dryer button to turn on the dryer function and the dryer indicator will be on. The
dehumidifier will be operated in high wind speed and continuous dehumidifying, it could help to
dry the laundry.
7. Air clean button
Press air clean button to start the function of air clean and the air clean indicator will be on.
PRECAUTIONS
1. The humidity setting should not be set higher than the ambient humidity to operation.
2. When the water tank is full or the water tank full indicator is on, drain the water, and install the
empty water tank back to its position. The appliance can continue its operation.
3. The operational temperature range of this appliance is 5-32
4. If the plug and power supply are in normal condition, and the dehumidifier does not start, please
unplug to wait for 10 minutes and restart the appliance (as it takes around 10 minutes to reposition).
If the appliance still does not start after 10 minutes, please contact the service center.
5. When the dehumidifier is in operation, the running compressor will get hot and the room
temperature will be increased. This is normal.
6. The built-in defrosting sensor detects room temperature and will cease the operation of the
compressor for about 10 minutes when room temperature is below 15
o
C.
o
C.
3