Operation Instruction - KARUIZAWA KDH2016 User Manual

OPERATION INSTRUCTION

*Connect the power cord to the correct power supply. The power indicator will be on and the dehumidifier
will be in standby mode.
1. ON/OFF button
Press the ON/OFF button to turn on the dehumidifier. The mode indicator "Cont" will be on. "50%"
will be displayed on the LCD display for about 10 seconds, and the room humidity will be displayed
afterwards. The preset mode is Cont, dehumidifying by 50% and high fan speed. In dry mode, speed
cannot adjust. The fan speed indicator will not be on. Press the ON/OFF button again to turn off
the dehumidifier.
2. Timer button
Auto on timer (1-24 hours) setting - Press the Timer button in standby mode, the timer indicator will
be on, and the LCD display will show the set auto on time. The original set value is 00h. Press the
timer button again to set the auto on time. For each press, the set auto on time will be increased by 1
hour. The maximum set auto on time is 24 hours. The LCD display will be off after 5 seconds. Auto
on timer setting will be completed. The appliance will start operation by the present time.
Auto off timer setting - Press the Timer button during operation, the timer indicator will be on, and
the LCD display will show the set auto off time. The original set value is 00h. Press the timer button
again to set the auto off time. For each press, the set auto off time will be increased by 1 hour. The
maximum set auto off time is 24 hours. The LCD display will return to the room humidity after 5
seconds. Auto off timer setting will be completed. The appliance will stop operation by the preset time.
Note: Press the timer button to increase the set auto on/off time until it has turned back to 00h to
cancel the timer setting. The timer indicator will be off.
3. Humidity button
Humidity setting can only be performed under Auto mode. Press the humidity button to set the
humidity. For each press of the Humidity button, the humidity will be increased by 10%¸ from
30-80%. The LCD display will be returned to the room humidity after 5 seconds. Humidity setting
will be completed. Humidity control system will be started in 5 minutes after start-up. If the setting
-up humidity is about 10% higher than the actual humidity, the compressor will be stopped with the
fan keep working. If the setting-up humidity is about 5% lower than actual humidity, the compressor
will be restarted.
4. Mode button
Press the Mode button to select different operating modes, press once to change the modes among
Auto, Cont and Dry.
Auto mode: The Auto mode indicator and the fan speed (High) indicator will be on. The fan speed
can be adjusted. If there is no set humidity, the appliance will maintain ranging from
40%-60%, subject to the ambient temperature level. If there is a set humidity, the
appliance will operate accordingly.
Cont mode: The Cont mode indicator and the fan speed (High) indicator will be on. The fan speed
can be adjusted. The appliance will continue to dehumidify until the humidity is
decreased to below 20% or water tank full.
Dry mode: The Dry mode indicator will be on. The fan will operate in high fan speed. The appliance
will continue to work and stabilize the humidity to avoid mildew after finished drying.
Under dry mode, the fan speed and the humidity cannot be adjusted and the fan speed
indicator will not be on.
3