Table of Contents
Advertisement
QUICK START OPERATOR MANUAL
FOR THE FOLLOWING CLEANERS
Thank You
Thank You for entrusting us with keeping your pool clean. We strive
to enhance your pool experience by keeping your pool environment
healthy for you, your family and your friends. Please read this Quick
Start Manual in its entirety to ensure proper operation and care of your
cleaner. Please feel free to leave a review online.
FOR YOUR RECORDS, PLEASE KEEP A COPY OF YOUR
SERIAL NUMBER AND DATE OF PURCHASE HERE
IMPORTANT:
PLEASE READ BEFORE OPERATING CLEANER
• SAFETY INSTRUCTIONS
• POWER SUPPLY
• WHAT TO EXPECT
• HOW TO GUIDE
• QUICK START
• TROUBLESHOOTING
ITEM: 820???
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Aqua Products Aquabot
Summary of Contents for Aqua Products Aquabot
- Page 1 QUICK START OPERATOR MANUAL FOR THE FOLLOWING CLEANERS Thank You Thank You for entrusting us with keeping your pool clean. We strive to enhance your pool experience by keeping your pool environment healthy for you, your family and your friends. Please read this Quick Start Manual in its entirety to ensure proper operation and care of your cleaner.
- Page 2 WARNINGS & SAFETY PROCEDURES A Ground Fault Current Interrupter (GFCI) outlet must be installed to protect your electric outlet and prevent any possible electric shock. • The connection to the branch circuit should be consistent with local and national wiring electrical codes. •...
-
Page 3: What To Expect
WHAT TO EXPECT YOUR ROBOT’S TYPICAL CLEANING METHOD Your robotic pool cleaner is designed to clean the dirt and debris from the pool bottom; and in some pools the cove and lower wall . Below is the typical pattern your cleaner will attempt in your pool. Pool dimensions and cleaning surfaces vary from pool to pool so coverage and cleaning patterns may vary. -
Page 4: Quick Start
QUICK START *Please see Page 5 for power supply variations. Straighten out the floating cable and plug the cleaner into the Place the cleaner in your pool in the shallow end and turn power supply. DO NOT plug the power supply’s power cord upside down to remove any air bubbles. -
Page 5: Power Supply Operation
POWER SUPPLY OPERATION STANDARD POWER SUPPLIES The pool cleaner will start working as soon as the power supply is plugged into the wall outlet and the floating cable is plugged into the power supply socket. The indicator light on the power supply lights up to confirm that the cleaner is working. -
Page 6: Clean The Filters
HOW TO... REMOVE THE ROTATING SCRUBBING BRUSH This model comes complete with a rotating scrubbing brush located underneath cleaner. This brush is a moving part and is powered by your cleaner. It is meant to pass over surfaces and scrub as a an additinal complimentary cleaning method. - Page 7 TIP #4: GIVE IT A RINSE Use only as much cable as you need. Limit After use, remove your Aquabot from the pool and rinse the the amount of cable to reach the furthest outside AND inside thoroughly. Doing so will help prolong the wall.
-
Page 8: Troubleshooting
TROUBLESHOOTING MOVES SLOWLY OR DOESN'T SEEM TO BE VACUUMING The solution is to make sure that the filter basket is clean. • Check to see that the suction ports are not clogged or blocked. • ALL LED LIGHTS ARE BLINKING ON THE POWER SUPPLY Check to see if the unit is out of water.
Need help?
Do you have a question about the Aquabot and is the answer not in the manual?
Questions and answers
My ep37 is just floating at times. And it is staying in one corner
The Aqua Products Aquabot EP37 may float and stay in one corner because the floating cable is coiled up. This can cause the unit to turn too sharply or in the same direction for too many cycles, limiting its movement. Letting the tangled cable lay flat in the sun can help make it more pliable and easier to straighten. Also, avoid placing more cable in the pool than needed.
This answer is automatically generated