International 710 Operator's Manual page 31

ON-THE-LAND OPERATION
-
Continued
Cylinder
thumb
screw
SETTING UP
Six-furrow
location
furrow,
16-inch
5-furrow, 18-inch
6-furrow, 18-inch
6-furrow, 16-inch
Five-furrow
location
MA
333f A
lllust.
29
Note:
Assembly
is
apt to
be easier
if
all
bolts
are
assembled
loosely in
place, after
which
all
bolts
are tightened.
1.
Bolt the pull
beam
connecting plates
to the
main frame diagonal
member.
Install
hose
clamp
as shown.
2.
Bolt the pull
beam
and connecting
plates together.
3.
Bolt
the
parking stand
to
pull
frame.
Use
3/4
x
7-inch carriage bolt
and secure
with handle.
4.
Locate and bolt the
spreader mounting
and
clip.
5.
Bolt
the
spreader
to
the front of the
main frame and the
mounting
clip.
Install
mounting spacer
at
the
rear side of the
spreader.
Note: See
lllusts.
17,
17A, 18 and
18A for
proper
location.
6.
Feed
the
axle
through
the slot in
the
spreader
until
it
is in its
approximate
position.
7.
Bolt the axle
bearing
to the pull
beam.
Note: See
lllusts.
17,
17A, 18 and
18A for
proper
location of bolts,
and washers used on each
side of
the axle
bearing.
See
lllust.
28A
for
proper
tie
rod anchor and the
hose
clamp
location.
Note: Install
the
rear
bolt
down
through
the axle
bearing
plate to
prevent cylinder
interference.
See
lllust.
28A.
8.
Automatic
Trip:
Bolt the first
colter rail
to
the
left
side of
the
recovery
beam
pivot
bracket.
Be
sure to install
the
1/4-inch
beam
spacer between
the
recovery
beam
pivot
bracket and colter rail to
insure
proper alignment
of
the
wheel support
bracket.
Spring
Trip:
One
1/4-inch spacer should be
installed
on each
side of
the first
colter
rail
to
insure
proper alignment of the
wheel
support bracket.
9.
Bolt the
wheel
support bracket
to
the
spreader and
the colter stub
rail.
Install
bearing "C".
(lllust.
30A).
Note:
If
rolling colters
are used,
install
colter
shank and
cap.
10. Install the
front
furrow wheel
axle
housing and
the
upper
arm
to the
cross axle
29