Philips 6423LC Owner's Manual page 8

ENGLISH
14
Turn Razor Head Assembly over so that
4
underside is exposed.
C
Turn wheel of frame counterclockwise.
5
Remove the frame and brush clean.
6
C
Remove and clean one cutter and comb at
7
a time.
Do not clean more than one cutter and comb at
a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
Separate the cutter from the comb.
8
C
Only brush the cutter in an upward motion.
9
Use the short bristled side of the brush.
C
Brush the slots of the comb.
10
For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
(e.g. Philips Norelco Razor Head Cleaner, model
RC1776 or alcohol) and lubricated with Philips
Norelco Razor Lubricant, model AL80, or one
drop of mineral oil (in the center of the head).
This helps prevent wear of the shaving heads.
C
Replace the cutter and comb into the
11
Razor Head Assembly.
Repeat the process for the other two sets
12
of cutters and combs.
Replace the frame.
13
C
Turn the wheel clockwise until it locks into
14
place.
C
Replace the Razor Head Assembly back on
15
razor.
Put the protective razor head cap on the
16
razor to protect heads.
After Each Use:Trimmer
Turn razor to OFF (O) position.
1
C
Push trimmer slide switch up to pop up
2
trimmer.
C
Clean trimmer with the brush every time
3
you use it.
C
Lubricate the trimmer teeth with Philips
4
Norelco Razor Lubricant (model AL80) or
with one drop of mineral oil every 6 months.
Close trimmer by sliding trimmer switch
5
down.
This razor has no other user-serviceable parts.
Any other service should be performed by the
Philips Norelco Service Location.
ENGLISH
15 15