Turning The Power On/Off; Specifying The Harmony Reference Pitch - Boss Acoustic Singer Live ACS-LIVE Owner's Manual

Panel Description

Turning the Power On/Off

* Once everything is properly connected (p. 6), be sure to follow
the procedure below to turn on their power. If you turn on
equipment in the wrong order, you risk causing malfunction or
equipment failure.
1.
Make sure that the Acoustic Singer's [MASTER]
knob and the volume of the devices connected to
the Acoustic Singer are set to 0.
2.
Turn on the Acoustic Singer.
* Before turning the unit on/off, always be sure to
turn the volume down. Even with the volume
turned down, you might hear some sound when
switching the unit on/off. However, this is normal
and does not indicate a malfunction.
3.
Turn on the power of the devices
connected to the LINE OUT jack,
PHONES jack, and REC OUT O port.
4.
Use each channel's [VOLUME] knob and [MASTER]
knob to adjust the volume of the Acoustic Singer.
5.
Adjust the volume levels for the connected devices.
Before switching off the power, lower the volume on each of the
devices in your system and then TURN OFF the devices in the
reverse order to which they were switched on.
* If you need to turn off the power completely, first turn off the
unit, then unplug the power cord from the power outlet. Refer
to "To completely turn off power to the unit, pull out the
plug from the outlet" (p. 2).
8

Specifying the Harmony Reference Pitch

Here's how to specify the reference pitch that is used when adding
harmony. Match this reference pitch to the tuning of your guitar
or other accompaniment instrument.
1.
Long-press the [TYPE] button.
The Acoustic Singer is in harmony reference
pitch setting mode.
2.
Use the [TYPE] button to select a
reference pitch.
Each time you press the button, you'll cycle
through the following settings in the order of 1–7.
Indicator
1 UNISON lit
2 UNISON+HIGH lit
3 UNISON+HIGH blinking
4 HIGH blinking
5 UNISON+LOW lit
6 UNISON+LOW blinking
7 LOW blinking
3.
Long-press the [TYPE] button to exit reference
pitch setting mode.
* This setting is remembered even when the
power is switched off. When you switch on the
power and enter reference pitch setting mode,
the currently specified setting (1–7 listed
above) is shown.
Explanation
440 Hz (factory setting)
441 Hz
442 Hz
443 Hz
439 Hz
438 Hz
437 Hz