Table of Contents
Advertisement
(2) Demonstration mode for shop display
Setting
Within 1 minute after power supply turns on, press the
with the door of the ice making compartment opened.
When the setting is complete, a "beep" sound is heard and "Auto Demo Mode" is displayed.
Demonstration mode is not available when the temperature of freezer compartment is –7°C or lower.
Panel operation mode during demonstration mode
The panel operation mode changes to "manual" if any of the switches is pressed. It changes to "auto" if none of the switches
is pressed for 45 seconds since the last time any of the switches was pressed.
Manual mode: Panel indication changes according to switch operation.
Auto mode: Panel indication is automatically changed.
Release
1) Open the ice making compartment's door during demonstration mode, and leave it open.
2) Press
button twice.
3) Simultaneously press
Verify that the room display and the temperature adjustment display on the operation panel do not light by turns a minute
after the 3 steps above are performed.
Note: Follow the procedure above to release demonstration mode as it cannot be released by simply turning
on/off the power supply.
(3) Fine adjustment of temperature
Fine adjustment of temperature is available for refrigerator compartment, freezer compartment and versa
compartment.
As for versa compartment, however, it is only available when the compartment is set to
Setting
Simultaneously press
Room display blinks every 10 seconds in fine adjustment mode.
Fine adjustments of temperature
Follow the same operation procedure for temperature adjustment.
Fine adjustment of temperature
Normal mode
Fine adjustment mode
Release
Follow the same procedure as Setting and the finely-adjusted
temperatures are reset for refrigerator compartment, freezer
compartment and versa compartment at once.
Temperature is adjusted in approximately 0.3 to 0.6°C
increments.
(4) Ice making test/Self-check
Setting
Press
for about 5 seconds.
Operation and its display
While automatic ice making is testing, the indication of ice
making compartment setting blinks on display.
When something is faulty, the error code is indicated.
Release
The test automatically finishes in 10 minutes.
,
, and
for 5 seconds. (A "beep" sound is heard in about 5 seconds.)
and
for about 3 seconds until a "beep" sound is heard.
,
, and
simultaneously for 5 seconds
Note: -25 °C freezing.
S e l e c t t h e m a x i m u m s e t t i n g o f t h e
temperature adjustment function for the
freezer compartment.
There is no particular display when the
setting is selected.
(5) "LOW" setting on the anti-condensation heater
Outline
This setting lowers energy on the anti-condensation heater,
allowing for lower power consumption.
If, however, the condensation forms on the partitions, cancel
the setting.
Setting
Press
and
(until 1 beep sound is heard ).
Cancellation
Go through the same procedure as that of Setting (2 beep
sounds are heard when cancelled).
When the settings are reset, this setting is also cancelled.
Display/indication of the setting status
No display is available to show the low setting state on the
anti-condensation heater.
The number of beep sounds indicates the setting state.
Beep (1 time)
Beep beep (2 times)
11
.
buttons simultaneously for 3 seconds
Set to Low
Low setting is canceled and returned to normal state.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
