Table of Contents
Advertisement
3
Installation
Transportation
Instructions
1. The appliance should be
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2. If during the course of
transport the appliance has to be
transported horizontally, it must only
be laid on its right hand side when
standing in the front of the appliance.
After bringing it to upright position,it
must not be operated for at least 4
hours to allow the system to settle.
Failure to comply with the
3.
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be
protected against rain, moisture and
other atmospheric influences.
5. When positioning your
appliance take care not to damage
your flooring, pipes, wall coverings
etc. Do not move the appliance by
pulling by the door or handle.
6. Empty any water in the drain
tray before moving. See section
'Defrosting' and 'Care & cleaning' for
further information.
Important :
Care must be taken while cleaning
/ carrying the appliance to avoid
touching the bottom of the condenser
metal wires at the back of the
appliance as you might injure your
fingers and hands.
Important :
This appliance is not designed for
stacking with any other appliance.
1. Do not attempt to sit or
stand on top of your appliance as
it is not designed for such use. You
could injure yourself or damage the
appliance.
Important :
Make sure that mains cable is not
caught under the appliance during and
after carrying / moving the appliance,
to avoid the mains cable becoming cut
or damaged."
2. Do not allow children to play
with the appliance or tamper with the
controls.
3. BEKO plc declines to accept any
liability should the instructions not be
followed.
Installation Instructions
1. The space in the room where
the appliance is installed must not be
smaller than 10 cubic metres.
2. If possible avoid placing the
appliance near cookers, radiators or in
direct sunlight as this will cause the
compressor to run for long periods. If
installed next to a source of heat or
refrigerator, maintain the following
minimum side clearances:
From Cookers 2" (50 mm)
From Radiators 12" (300 mm)
From Refrigerators orFreezers1"(25
mm)
Allow a minimum of 60
3.
mm (2.4 inches) between the top
of the fridge and the ceiling or the
underside of a wall cupboard.
11
EN
Advertisement
Table of Contents
