Features; Inductive Mode; 25' Coil Cords (When Extended) - RIDGID NaviTrack Operator's Manual

Pipe and cable line transmitter

Hide thumbs Also See for NaviTrack:

Table of Contents

Available languages

NaviTrack™ Line Transmitter

Features

1. Be sure that the transmitter is positioned correctly over

the line.

2. To use a frequency in the inductive mode select the

frequency and then push that same frequency a sec-

ond time. The inductive red LED will light up in ad-

dition to the selected frequency to let the user know

that the line transmitter is transmitting inductively on

that frequency.

Lower frequencies couple poorly, therefore the internal

coil has been optimized for higher frequencies. 512Hz

cannot be used inductively. (The transmitter will de-

fault to 33 kHz if an inductive clamp is used.)

Specially designed, hybrid copper and stainless steel air-

craft grade coiled cables allow the leads to be stretched

out to offer more freedom in choosing grounding points

and connections to the line.

To avoid tangled cords, "feed" the cords back into

the pockets, clip going last, when storing.

Like This:

Ridge Tool Company

Not like this

Table of Contents

Table of Contents