Regency MODEL L Installation And Operation Instructions

The Model L Remote Control is designed for use with decorative gas fireplace and wall heaters
using Millivoit gas valve.
The Model L Transmitter is a six-button hand held transmitter, which turn the gas on/off or as a thermostat.
The display of the transmitter shows the clock, current room temperature, target temperature, timer setting,
on/off status and low battery indicator.
Installation Precautions:
The Model L Remote Control is tested safe when installed in accordance with this installation manual. It is
your responsibility to read all instruction before starting installation and to follow these instructions carefully
during installation.
The Model L Remote Control MUST be installed by a qualified service technician.
The Model L Remote Control is carefully engineered and MUST be installed only as specified. If you modify
it or any of its components, you may possibly cause a fire hazard.

FCC Requirements

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compli-
ance could void the user_ authority to operate the equipment. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 to the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
_
Reorient or relocate the receiver antenna.
_
Increase the separation between the equipment and receiver.
_
Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
_
Consult the dealer or an experienced radio TV technician for help.
Canadian Equipment Requirements
This digital apparatus does not exceed the (class A/Class B)* limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
Le present appareil numerique n_met pas de bruits radioelectriques depassant les limites applicables aux
appareils numeriques (de la class A/de la class B)* prescrites dans le Reglement sur le brouillage
radioelectrique edicte par le ministere des Communications du Canada.
This device complies with RSS-210 of Industry and Science Canada. Operation is subject to the following
two conditions : (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
All wiring should be done by a qualified electrician and shall be in compliance with local codes and with the
National Electirc Code ANSI/NFPA No. 70-current (In the United States), or with the current CSA C22.1
Canadian Electirc Code (in Canada).
Fireplace Remote Control
Installation and Operation Instructions:
Model L
page 1 of 4 MODEL L VERSION:A