Replacing The Globrite Light Assembly (After Electrical Requirements Are Met) - Pentair GLOBRITE Installation And User Manual

12
REPLACING THE GLOBRITE
(AFTER ELECTRICAL REQUIREMENTS ARE MET)
The following removal and installation instructions describe how to remove and install the
GloBrite light assembly.
™
Failure to bring the pool or spa's electrical system up to code requirements
before installing the underwater light will create an electrical hazard which
could result in death or serious injury to pool users, installers, or others due to
electrical shock, and may also cause damage to property.
1.
Switch off electrical switch or circuit breaker at the source. Note: DO
service the light while in the pool water. Service the light
NOT
on the deck.
2. Remove Junction Box or Transformer cover. Disconnect the light wires and
attach a fish tape to the existing light power cord. This will assist in pulling
the replacement light power cord through the conduit back to the junction
box.
3.
Remove the GloBrite light assembly from the pool or spa water and
place it on the deck: Using the provided installation tool (P/N 620057),
rotate the light assembly counter-clockwise about a 1/8th turn to release the
light from the niche as shown on page 10).
4. Slowly pull the light and attached power cord (with attached fish tape) out of
the niche. Pull the light's power cord and fish tape out of the niche and place
the light on the deck.
5. Attach the new light power cord to the fish tape and carefully feed the fish
tape and cable to the junction box.
6. Install the light into the niche: Place the light installation tool over the front
of the light. Turn the tool and light clockwise while pushing inward, until you
feel the stop point. This indicates the light is properly seated, locked and the
electrical conduit, is completely sealed (see page 10).
Note: If the light does not turn smoothly, pull the light slightly out and be sure
that it's seated properly and the niche is free of debris, then install the light
as described in step 5.
7. Connect the two (2) conductors to the corresponding circuit wires in the
Junction Box (black wire to power, white wire to common) and secure the
Junction Box cover in place.
8.
Final check for proper GloBrite
switch or circuit breaker to the 12 VAC transformer and the switch that
operates the light itself. The light should illuminate when 12 VAC power is
applied. If not recheck the installation steps.
GLOBRITE™ White LED Light Installation and User's Guide
™
LIGHT ASSEMBLY
light operation: Switch on the main
™