Step 2: Connecting Speakers; Step 3: Connecting The Control Cable; Step 4: Connecting - Philips MCD908/37 Owner's Manual

Connections

Step 2: Connecting speakers

●
Connect the left and right speakers to the
SPEAKERS (4Ω) terminals on the back of the
power amplifier with the supplied speaker cables.
Right speaker to "R" and left speaker to "L", red
wire to "+" and black wire to "-". Fully insert the
stripped portion of the speaker wire into the
terminal as shown.
1
Speaker wire connection on main set
1
Speaker wire connection on speakers
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
12
2
3
2
Step 3: Connecting the control
cable
●
Connect the serial port marked "CONTROL
CABLE" at the rear of the DVD player to the
same port at the rear of the power amplifier
with the supplied flat control cable.
Step 4: Connecting TV
IMPORTANT!
– You only need to make one video
connection from the following options,
depending on the capabilities of your TV.
– Connect the DVD system directly to
the TV.
Using Composite Video jack
1
Use the composite video connectors (yellow) of
the supplied audio and composite video cables
(2-in1) to connect the DVD system's VIDEO
OUT jack to the video input jack (or labeled as
A/ V In, CVBS, Composite or Baseband) on the
TV.
2
To hear the TV channels through this DVD
system, use the audio connectors (white/ red) of
the supplied audio and composite video cables
(2-in1) to connect AUX IN L/R jacks to the
corresponding AUDIO OUT jacks on the TV.