Philips 22PFS4022 User Manual page 23

Satellite (if available)
About Installing Satellites
Up to 4 Satellites
You can install up to 4 satellites (4 LNBs) on this TV.
Select the exact number of satellites you wish to
install at the start of the installation. This will speed up
the installation.
Unicable
You can use a Unicable system to connect the
antenna dish to the TV. You can select Unicable for 1
or for 2 satellites at the start of the installation.
MDU - Multi-Dwelling-Unit
The built-in satellite tuners support MDU on the Astra
satellites and for Digiturk on the Eutelsat satellite.
MDU on Türksat is not supported.
Start the Installation
Update Channels
 (Home) > Settings > Satellite
installlation > Search for satellite > Update
channels
You can always start an channel update manually,
new channels will be added, and unavailable
channels will be removed.
Enter PIN code if necessary.
Re-install Channels
 (Home) > Settings > Satellite
installlation > Search for satellite > Re-install
channels
You can search satellites and channels again
manually.
1. Select one option you need to re-install.
2. Select Settings or select Start to update channels.
Settings Menu

Press Reset to reset, or press
complete the settings.
- Connection type
Select the number of satellites you want to install.
The TV sets the appropriate connection type
automatically.
• Up to 4 Satellites - You can install up to 4 satellites
(4 LNBs) on this TV. Select the exact number of
satellites you wish to install at the start of the

Done when
23
installation. This will speed up the installation.
• Unicable - You can use a Unicable system to
connect the antenna dish to the TV. You can select
Unicable for 1 or for 2 satellites at the start of the
installation.
- LNB settings
In some countries, you can adjust the expert settings
for homing transponder and each LNB. Only use or
change these settings when a normal installation fails.
If you have non-standard satellite equipment, you
can use these settings to overrule the standard
settings. Some providers might give you some
transponder or LNB valeus which you can enter here.
• LNB Power - By default, LNB Power is set to On.
• 22 kHz Tone - By default, the Tone is set to Auto.
• Low LO Frequency / High LO Frequency - The local
oscillator frequencies are set to standard values.
Adjust the values only in case of exceptional
equipment that needs different values.
Enter PIN code if necessary.
Add Satellite or Remove Satellite
 (Home) > Settings > Satellite
installlation > Search for satellite > Add satellite
or Remove satellite
 (Home) > Settings > Satellite
installlation > Search for satellite > Add satellite
• You can add an additional satellite to your current
satellite installation. The installed satellites and their
channels remain untouched. Some satellite operators
do not allow adding a satellite.
• The additional satellite should be seen as an extra, it
is not your main satellite subscription or not the main
satellite of which you use its channel package.
Typically, you would add a 4th satellite when you
have 3 satellites already installed. If you have 4
satellites installed, you might consider removing one
first to be able to add a new satellite.
• If you currently have only 1 or 2 satellites installed,
the current installation settings might not allow
adding an extra satellite. If you need to change the
installation settings, you must redo the complete
satellite installation. You cannot use Add satellite if
a change of settings is needed.
 (Home) > Settings > Satellite
installlation > Search for satellite > Remove
satellite
You can remove one or more satellites from your
current satellite installation. You remove the satellite
and its channels. Some satellite operators do not
allow removing a satellite.