Step 2: Connecting Speakers; Step 3: Connecting The Control Cable; Step 4: Connecting - Philips MCD728/93 User Manual

Connections

Step 2: Connecting speakers

1
Connect the speaker wires to the SPEAKERS
terminals, right speaker to FRONT (4Ω) R and
left speaker to FRONT (4Ω) L. Fully insert the
connectors on the cables into the terminals and
fasten the hooks to ensure firm connection.
2
Connect the passive subwoofer to the
SUBWOOFER (8Ω) terminal with the
supplied subwoofer cable by matching the plug
types.
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
10
Step 3: Connecting the control
cable
●
Connect the serial port marked "CONTROL
CABLE" at the rear of the DVD player to the
same port at the rear of the power amplifier
with the supplied flat control cable.
Step 4: Connecting TV
IMPORTANT!
– You only need to make one video
connection from the following options,
depending on the capabilities of your TV.
– Connect the DVD system directly to
the TV.
Using Composite Video jack
1
Use the composite video cable (yellow) to
connect the system's VIDEO jack to the video
input jack (or labelled as A/V In, Video In,
Composite or Baseband) on the TV set.
2
To listen to the TV channels through this DVD
system, use the audio cables (white/red-not
supplied) to connect AUX IN L/R jacks to the
corresponding AUDIO OUT jacks on the TV.