Clock/Timer
PRESET
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
●
The system can be used as an alarm clock,
whereby the last selected source is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can
be used.
1
In standby mode, press and hold TIMER on the
remote for more than three seconds.
➜
"SET TIMER" is displayed briefly. Then, the
hour digits flash on the display panel.
2
Turn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
hours and press TIMER on the remote to
confirm.
➜
The minute digits flash on the display panel.
3
Turn the VOLUME control on the front panel
or press VOL +/- on the remote to set the
minutes and press TIMER on the remote to
confirm.
➜
"ON" or "OFF" flashes.
36
TUNING
4
Turn the VOLUME control on the front panel
or press VOL +/- on the remote to activate or
deactivate the timer and press TIMER on the
remote to complete the setting.
➜
Display shows
if deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1
Press SLEEP on the remote control repeatedly
to select a preset time.
➜
The selections are as follows (time in
minutes):
0FF™010 ™ 020 ™ 030 ™ 040 ™ 050 ™
060 ™ 070 ™ 080 ™ 090™ 0FF
➜
"SLEEP XX" is displayed. "XX" is the time in
minutes.
2
When you reach the desired length of time, stop
pressing the SLEEP button.
To deactivate the sleep timer
●
Press SLEEP repeatedly until "0FF" is displayed,
or press STANDBY ON y.
ANGLE
A-B
MODE
PROGRAM
IS
DSC
if activated, and disappears